Like you, I spent years looking for replacement feet for my Wear-Ever juicers.

Then 3D printing came along, and I ended up making my own. I made extras.

Each replacement foot pad is individually fashioned to precise dimensions using 3D print technology. Made from a more superior material than the original, they will never dry out and crack.

In my pursuit for Wear-Ever replacement feet, I discovered there are 2 versions of the beloved juicer out there. One is the American model, made with slightly smaller diameter feet and pads. The other is Canadian made and have slightly larger diameter feet and pads than the original US Wear-Ever juicer. It is important to know which model you need feet for, as they come in both sizes.

Wear-Ever Juicer Made In USA

The American model can be identified by looking for Made in USA on the side of the handle.

Wear-Ever Juicer replacement feet are sold in sets of 4

While the replacement feet are made to exact size, the juicers were not. Especially the earlier American made ones. While they all have the same smaller diameter, the depth of the holes that hold the feet pads vary.

Wear-Ever Juicer Made in Canada

The Canadian model is marked Made in Canada on the underside of the handle.

Instructions – How to replace your Wear-Ever juicer feet

Remove the old dried out pads and clean the holes of any debris from the old feet.

Place a drop of super glue into the hole and use the glue nozzle to move some of it up the sides of the hole.

Put the replacement pad in place. Repeat for all feet.

Sit juicer right side up on its new feet. Wait 5 mins and you’re done!